Hochfrequenz Elektroneninjektoren für cw-Beschleuniger

Abstract
For today 's applications of superconducting accelerators like Linear Colliders and Free Electron Lasers (FEL) there is an increasing demand for high brightness beams. So get a high luminosity or high average laser beam power, the accelerator has to operate in cw mode or with a high duty factor. Therefore, new injectors are needed, delivering a low emittance beam with high average currents compatible to the acccelerator's macropulse structure. During the last 14 years the development of rf guns gained more and more importance for normal conducting accelerators. In this field they became the most advanced injector for high brightness beams. Nevertheless, because of the high rf losses they are, like normal conducting accelerators, limited to operation with low duty factors. At Forschungszentrum Rossendorf two concepts were developed to transfer the merits of the rf gun design to injectors with high duty factors. The first project is a thermionic 1.3 GHz rf gun with two decoupled cavities. A combination of rf and dc acceleration allows to operate the copper cavities at low gradients in cw mode. The design parameters of the injector are a low bunch charge of 1 pC with an emittance less than 1 π mm mrad. Because of the high repetiton rate of 1.3 GHz an average current of 400 µA can be reached. A test stand for the injector with a beamline for emittance, energy and bunch length measurement was built up. At average beam currents up to 80µA a normalized transverse emittance of 0.23 π mm mrad was measured. The measured energy width of 8 keV and the bunch length of 8 ps (FWHM) is in a very good agreement with the simulation results. The second project was realized in collaboration with the Budker Institute in Novosibirsk. The goal is the development of a photocathode rf gun with a superconducting cavity operating at high gradients in cw mode. A new design was worked out to solve the related rf and thermal problems. The beam dynamics of a superconducting 3½-cell rf gun were studied in detail by simulation. The resulting ernittance of 5.3 π mm mrad at a bunch charge of 200 pC opens a wide range of applications for high average power FELs. The fabrication of a half cell test cavity was finished in October 1997. First tests are scheduled for the middle of 1998 to prove the feasibility of our design.